Serial Port Configuration
Allows you to set the parameters of the serial ports.
This item only functions only if there is a serial port (COM1) connector connected to the motherboard.
Serial Port [Enabled]
Allows you to enable or disable the serial port.
Configuration options: [Disabled] [Enabled]
The following item appears only if you set the Serial Port to [Enabled].
Change Settings
Allows you to select an optimal setting for Super I/O device.
2.6.8APM
ErP Ready [Disabled]
Allows you to switch off some power at S4+S5 or S5 to get the system ready for ErP requirement. When set to [Enabled], all other PME options will be switched off.
Configuration options: [Disabled] [Enabled (S4+S5] [Enabled (S5)]
Restore AC Power Loss [Power Off]
[Power On] | The system goes into ON state after an AC power loss. |
[Power Off] | The system goes into OFF state after an AC power loss. |
[Last State] | The system goes into either OFF or ON state, whatever the system state |
| was before the AC power loss. |
Power On By PCIE/PCI [Disabled]
[Disabled] | Disables the PCIE/PCI devices to generate a |
| Intel®/Realtek LAN device or other installed PCIE LAN devices. |
[Enabled] | Enables the PCIE/PCI devices to generate a |
| Intel®/Realtek LAN device or other installed PCIE LAN devices. |
Power On By Ring [Disabled]
Allows you to enable or disable the
Configuration options: [Disabled] [Enabled]
Power On By RTC [Disabled]
[Disabled] | Disables RTC to generate a wake event. |
[Enabled] | When set to [Enabled], the items RTC Alarm Date (Days) and Hour/ |
| Minute/Second will become |
Chapter 2: BIOS information |