Audiovox MPA6611X INSTALLATION

MPA6611X

When wiring is complete, reconnect the battery negative terminal.

If you require assistance, contact Technical Support at 1-800-323-4815 from 8:30am to 7:00pm

EST Monday through Friday and from 9:00am to 5:00pm EST on Saturday.

Before you can listen to XM® satellite radio, you must install the XM® Direct Receiver and

antenna (purchased separately). The XM® Direct Receiver is the central data receiving

equipment required to process the satellite signals from the external antenna. It is typically

installed in the dash, under the seat, or in the trunk or rear of the vehicle. Do not mount the

XM® Direct Receiver near a heater vent or where it can be exposed to extreme temperatures.

In addition, when running the wire for the external antenna do not kink or pinch the antenna

cable. A sharp 90 degree bend or slight "nick" to the outer cable sheath will cause signal

degradation. The wiring diagram on page 3 will help you identify the proper connections.

INSTALLATION

This unit is designed for installation in cars, trucks and vans with an existing radio opening. In

many cases, a special installation kit will be required to mount the radio into the dashboard.

These kits are available at electronics supply stores and car stereo specialty shops. Always

check the kit application before purchasing to make sure the kit works with your vehicle. If you

have trouble locating a kit or need installation assistance, contact Technical Support at 1-800-

323-4815 from 8:30am to 7:00pm EST Monday through Friday and from 9:00am to 5:00pm

EST on Saturday.

1. Remove the detachable front panel, if it is attached to the chassis, by pushing the

“Release” button.

2. Slide the mounting sleeve off of the chassis if it has not already been removed. If it is

locked into position, use the removal keys (supplied) to disengage it. The removal keys

are depicted on page 5.

3. Check the dashboard opening size by sliding the mounting sleeve into it. If the opening is

not large enough, carefully cut or file as necessary until the sleeve easily slides into the

opening. Do not force the sleeve into the opening or cause it to bend or bow. Check that

there will be sufficient space behind the dashboard for the radio chassis.

4. Locate the series of bend tabs along the top, bottom and sides of the mounting sleeve.

With the sleeve fully inserted into the dashboard opening, bend as many of the tabs

outward as necessary to firmly secure the sleeve to the dashboard.