8
HIGH CURRENT (MONO) USAGE
The AV2600 has up to six output channels that may be paralleled (mono). This feature allows the amplifier to
increase its output power into lower impedance speakers. Set all ‘AMP ON’, ‘L + R’ and ‘BUS’ DIP switches to the
‘ON’ position for the desired channels. Set the ‘SENSE’ DIP switches to the ‘OFF’ position for these channels.
Place the volume jumpers for these channels to use the ‘NO VOL’ jumper terminals.
CHANNELS 1 AND 2CHANNELS 3 AND 4CHANNELS 5 AND 6
JUMPER
JUMPER
VOL
NO VOL
NO VOL
VOL
JUMPER
JUMPER
VOL
NO VOL
NO VOL
VOL
JUMPER
VOL
NO VOL
NO VOL
VOL
JUMPER
JUMPER
= JUMPER SHORT
Figure 8
The desired speaker output terminals on the AV2600 rear panel must now be paralleled in order to complete the
setup. Connect the (+) terminals for all desired channels together using jumper wires (not supplied with the
amplifier). Finally, connect a speaker cable from one of the paralleled amplifier channels to the speaker terminals.
Input the signal source into the audio BUS input. The illustration below shows an example of two channels
connected in parallel.
Figure 9
Figure 10
PLUSPLUSPLUSPLUSPLUS PLUS MINUS
(+)
(-)
SPEAKER
OUT 6
MINUS MINUS MINUS MINUS
OUT 5 OUT 4 OUT 3 OUT 2 OUT 1
MINUS
OUT
MASTER
CONTROL
OUT IN
BUS
OUT
IN IN