Barco D320 3. PHYSICAL INSTALLATION

3. PHYSICAL INSTALLATION

• TheDigitizer should not be placed in a built-in installation or enclosure unless proper ventilation is provided.

• When using theun itin a multi-unit rack assembly or closed assembly, the ambient temperature inside the assembly may not

exceed the maximum rated ambient temperature of the Digitizer. The installation should be such that the amount of air flow

requiredfor safe operation of the equipment in not compromised.

• When building in the Digitizerinto a rack with cover door, be aware that a space of 8,5 cm is needed between the indicated

referenceand the cover door. Thisspa ceis needed to guide the input cables to the inputs.

Image3-1

A Reference

• TheDigitizer will require that air flows freely in vent holes. Blocking these holes will greatly reduce the reliability of the unit and

lead to the possibilityof overheating.

• The Digitizershould operate from an AC power source. The Digitizer is equipped with Power Supply Autoranging from 90 to

264 volt (50–60 Hertz).

• When installed in a rack, the mounting should be suchthat no hazardous condition is achieved due to uneven mechanical

• Whenthe mains s witch located on the back of the Digitizer is not accessible due to rack mounting, the socket outlet supplying

the rack shall be installed near the equipment and be easily accessible or a readily accessible disconnect device shall be

incorporatedin the fixed wiring. When using a rack in an installation is advisable to log the serial number of the device and to

activatethe warranty figure by registering utilizing the included form.

• Donot place the Digitizer on an unstable cart, stand or table. Thedevice m ayfall, causing serious damage to it.

Image3-2

A Led-wallout

B PowerSwitch

C Powerinput

D Loopin

E Loopout

F Retractabledust filter

G RS232in

H Reserved

I RS232 out

J Ethernet LAN connector

K Monitorout

R5976388 D320 DIGITIZER 05112002 7