3. Kit installation (detailed)
Image3-17
inputmodule: fixingfront screws
4. Put the preformatter unit next to its correct position and plug in the connectors:
- J100,J101, J102 on the preformatter: data from connectors J823, J824 and J825 on the PMP
- J11onthe preformatter: power supply from connector 6 on the powerbox
- J410on the PMP :com mandsfrom connector J410 on the local keypad
- J13 on the PMP:com mands from theIR receiver
5. Use one screw to fix the three grounding wires to the preformatter
6. Fix the preformatter unit to the input module using four screws
Image3-18
Preformatterunit: front screws
7. Install the covers (see concerning chapters):
- engine fan cover 1
-topcover
- rear cover
3.3 Restoring the backup

Procedure

Restorethe backup using Projector Support tool. For more details, see "Backup and restoredata", page 15.
3.4 Upgrade the projector to the desired software version

Introduction

Projectorupgrade is done through Ethernet. Prior to starting the procedure below,make sure the Ethernet settings in the OSD are
setto the correct values to make Ethernet communication possible between computer and projector.
R59770498 PMP KIT 28/02/2011 13