1. Safety Instructions
1. SAFETY INSTRUCTIONS
1.1 Warnings
To preventpersonnel injury
The customer should never attempt to disassemblethe lamp casing or to dispose of the lamp casing other than by returning it to
BARCO.
Toprevent injuries and physical damage, always read this manual and all labels on the system before connecting to the wall outlet,
or adjusting the projector.
Toprevent injuries, take note of the weight of the projector. Minimum 4 persons are needed to carry the pro jector.
NEVER look into the lens ! Due to the high luminance damage to the eye can happen.
Beforeattempting to remove th e projector’s cover,you must turn off the projector and disconnect from the wall outlet.
Whenperforming set up work at a ceiling mounted projector, to prevent injury caused by falling objects or the system, set out a keep
out area.
Consulta professional structura l engineer prior to suspending the ceiling mount from a structure not intended for that use. Always
ensure the working load limit of the structure supporting the projector.
Thepower input at the projector side is considered as the disconnect device. Whenmentioned to switch of the projector, to access
somepa rts inside, always disconnectthe po wercord at the projecto rside.
To preventprojector damage
If the Air Filters are not regularly replaced, the air flow inside the projector could be disrupted, causing overheating. Overheating
may lead to the projectorshut tingdown during operation.
Inorder to ensure that correct airflow is maintained, and that the projector complies with Electromagnetic Compatibility requirements,
it should always be operated with all of it’scovers in place.
Ensurethat nothing can be spilled on, or dropped inside the projector. Ifthis does happen, switch off and unplug the mains supply
immediately. Do not operate the projector again until it has been checked by qualified service personnel.
Theprojector must always be mounted in a manner which ensures free flow of air into its air inlets and unimpeded evacuation of the
hotair exhausted from its cooling system. Heatsensitive materials should not be placed in the path of the exhausted air.
Special care should be used when DLP projectors are used in the same room as performant laser equipment. Direct or indirect
hittingof a laser beam on to the lens can severely damage the Digital Mirror Devices (TM) in which case there is a loss of warranty
To preventbattery explosion
Danger of explosion if battery is incorrectly replaced.
Replaceonly with the same or equivalent type recommended by the manufacturer.
Disposeof usedbatteries according t o the manufacturer’s instructions.
1.2 FCC statement
Federal Communication Commission (FCC Statement)
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercialenvironment. Thisequipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordancewith the instruction manual, may cause harmful interference to radio communications. Operationof this equipment in a
residentialarea may cause harmful interference, in which case the user will be responsible for correcting any interference.
1.3 Note
Definitions
DefinitionQualified service technicians or Qualified technicians : Personshaving appropriate technical training and experience nec-
essaryto be aware of hazards to which they are exposed in performing a task and of measures to minimize the danger to themselves
or other persons.
R5976563 BARCOR10 SLM 20/10/2004 1