Barco RLM W6 manual

RLM W6 Serial Commands

Rev. 6d

Page 1 / 14

Barco RLM W6 Serial (RS-232) Command

The RS-232 Commands use only ASCII characters which can be entered

using a typical terminal emulator like Windows HyperTerminal with the

following setting:

Bits per second: 38400

Data bits: 8

Parity: None

Stop bits: 1

Flow control: None

Note that each input character will be echoed on the terminal by MCU and

there is no need to set the local echo “ON” with the terminal setting.

 System Operation commands.

The Operation commands tell the projector what to do. All commands

start with 2 letters: “op” for operations commands, and a space [SP] then

following a control command then finally the value wants to read, set,

increase or decrease. All commands must end with a carriage return (ASCII

hex 0D), shown as [CR] below. The sy ntax for operations commands is as

follows:

op[SP]<operation command>[SP]<Setting Value>[CR]

For all but Execute functions the response from the projector will be the

command and “= <value>” where <value> is the current value or “NA” if the

value is not available. For Execute functions the response will be the same

command. All responses will be in CAPS. Please refer to the following

table for command list and examples:

System Operation command:

Operation Commands Values

Set = <value> Makes the unit take that value.

Get ? Asks what the current value is.