8. Installation Mode
If no 800 peripheral indication is made on the menu, there are still two possibilities, no RCVDS or VS05 connected or RCVDS is
switched off.
Whena 800 peripheral is connected to the projector, the input slots are not accessible with the cursor key to toggle their function.
8.3 800 peripheral
Overview
• Defining the output module of the RCVDS05.
• Defining the Infrared Communication protocol
• CLO using Comm 800
8.3.1 Defining the output module of the RCVDS05.
Which module are available?
Whena RCVDS05 is connected to the projector, the type of output module of this RCVDS05 has to be defined in the 800 peripheral
menu.
• standard output module
• 5 cable output module
Defining the output module
Todefine the output module:
1. Push the cursor key ↑or ↓to highlight 800 Peripheral.
INSTALLATION
INPUT SLOTS
800 PERIPHERAL
SOURCE SWITCHING
NO SIGNAL
CONTRAST ENHANCEMENT
CONVERGENCE
CONFIGURATION
LENS
QUICK ACCESS KEYS
OSD
INTERNAL PATTERNS
Select with ↑or ↓
then <ENTER>
<EXIT> to return
Menu8-5
2. Press ENTER to select.
3. Push the cursor key ↑or ↓to highlight Output module.
800 PERIPHERAL
OUTPUT MODULE [STANDARD]
CLO USING COMM800 [YES]
INFRARED [PPM]
Select with ↑or ↓
then <ENTER>
<EXIT> to return
Menu8-6
8.3.2 Defining the Infrared Communication protocol
Which protocols are available?
Whena peripheral is connected to the ’Comm Port’, the communication can be in PPM or RC5.
The type of communicationcan be set to :
•PPM
• RC5
R5976654 SLMR12+ 27/01/2005 97