5. Getting Started
1Barcokey selectionkey, to get direct access to the lens adjustment menus.
2ADJ ADJUSTkey, to enter or exit the adjustment mode.
3Address key (recessed key), to enter the address of the projector (between 0 and 9). Press the
recessed address key with a pencil, followed by pressing one digit button between
0and9.
4STDY stand-bybutton, to start projector when the powerswitch is switched on and to switch
offthe projector without switching off the power switch.
5PAUSE to stop projection for a short time, press ’PAUSE’. The image disappears but full power
isreta ined for immediate restarting.
6Help nline help information (not yet available)
7Digit buttons directinput selection
8Picturecontrols usethese butto nsto obtain the desired picture analog level.
9PHASE used to remove the instability of the image.
10 TEXT whenadjusting one of the image, e.g. controls during a meeting, the displayed bar
scalecan be removed by pressing ’TEXT’ key first. Tore-display the bar scale on the
screen, press ’TEXT’ key again. When TEXT is ’off’, no adjustment menu’s will be
displayedon the screen when entering the adjustment mode.
11 FREEZ press to freeze theprojected image .
12 ENTER to start up the adjustment mode orto co nfirm an adjustment or selection in the
adjustment mode.
13 EXIT toleave the adjustment mode or to scroll upwards when in the adjustment mode.
14 Cursorkeys (onRCU) or ’+’ and ’-’ keys (cursor keys) on the local keypad : tomake menu selections
whenin the adjustment mode or to zoom/focus when the direct accessis active.
Comparisonbetween the cursor keys and the use of th e ’+’and ’-’ keys on the local
keypad : RCU = local keypad
cursor key up = ’+’ key up
cursorkey dow n = ’-’k ey down
cursor key right = ’+’ key right
cursor key left = ’-’ key left
Usethe ’+’ and ’-’ keys (cursor keys) : to increase or decrease the analog level of the
image controls when they are first selected.
15 RCOperating indication lightsup when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
Table5-1
5.3 Operating the projector
5.3.1 Switching on
How to switch on.
1. Press the power switch to switch on the projector.
- When’0’ is visible, the projector is switched off.
- When’1’ is visible, the projector is switched on.
The projector starts i standby mode.
Starting image projection.
1. Press Stand by key once on the local keypad or on the remote control.
48 R5976654 SLM R12+ 27/01/2005