Install / Replace Batteries

SECTION 1

THE BATTERIES: The Meter uses two (3-volt lithium) batteries. These are furnished with the Meter.

WHEN TO REPLACE: When the battery voltage becomes weak (after approximately

1000 readings), the Meter will show a battery display ( ). When this display appears, it is time to replace the batteries (see page 40 for battery types). The Meter will continue to provide accurate results for a period of time until the batteries are exhausted. At this time, the Meter will “lock you out” from further testing.

DIRECTIONS:

1.With the tip of a finger, press the battery compartment lid latch toward the word “open.” Lift the lid.

2. Place the two new batteries into the battery compartment with the “+” side up and close the lid. NOTE: If replacing batteries, remove the old batteries from the compartment and discard.

Things to remember:

• WARNING: Keep batteries away from children. Lithium batteries are poisonous. If swallowed, immediately contact your physician.

• Discard batteries according to your local environmental regulations.

• The Meter memory will not be erased when

2batteries are changed.