Behringer V-AMP 3 manual 2

Page 2 of 5

Top tone—in full effect Stunning in the studio

VIRTUAL AMPLIFICATION V-AMP 3

Balanced stereo Line output can be configured for many recording and live applications

Adjustable auto-chromatic tuner plus effective global configurations and equalization easily adopts the V-AMP 3 to any situation outside your home studio

MIDI implementation includes program changes, control changes and SysEx, allowing complete MIDI remote control or automation with your preferred DAW

High-quality components and exceptionally rugged construction ensure long life

Conceived and designed by

BEHRINGER Germany

The V-AMP 3 gives you flanger, chorus, compression, delay and 12 other beautiful digital effects to apply to your sound.

Adjust the effect’s level in the mix via the EFFECTS dial. To adjust effect parameters, you can rhythmically press the TAP button to alter delay times or LFO speeds, or hold down the TAP button and twist the EFFECTS knob to access e.g. feedback or depth. By using a MIDI pedal, such as the BEHRINGER FCB1010, you can access an additional Wah Wah effect. You can adjust the filter characteristic by entering EDIT mode, selecting the DRIVE menu and turning the EFFECTS knob while holding the TAP button.

Presenting the presets

All of these elements have been combined into 125 different presets divided into 25 banks, accessible through the BANK UP/BANK DOWN buttons. Within each bank, you can press buttons A through E to explore its different presets. You can also create and save your own presets. Start by selecting a preset, then making any changes you wish: amp, EQ, effect, etc. The preset LED will begin to flash, indicating that the V-AMP

3 is ready to save your settings. To do this, hold the preset button down for about two seconds. Once the LED stops flashing, you have saved the modified preset.

On top of all this, the V-AMP 3 also features a built-in tuner and noise gate. In essence, it’s a Swiss Army Knife for the home recording enthusiast or gigging guitarist who can’t seem to settle

on one amp.

The V-AMP 3 features several configurations that make it an invaluable asset in the studio. Access the configuration menu by pressing the

B and D buttons at the same time. Then use BANK UP and BANK DOWN to select a configuration.

When using headphones, the V-AMP3 will switch into Studio Mode 1 (S1).

This stereo mode works well for both monitoring and recording with effects, amp and speaker modeling. It doesn’t apply the additional three-band EQ to the signal, but most recording programs have their own EQ.

In Studio Mode 2 (S2), the V-AMP 3 sends a signal with amp and speaker simulation, but only the right output has effects. You can either record both left and right outputs to separate tracks, or record the “dry” left output while monitoring the right output.

Stellar on stage

The V-AMP 3 has three live configurations. When performing live with this device, you can either run it to an amp on stage, run directly to the mixing board, or both. Live Mode 1 is the best choice for running the outputs directly to the mixer, because it applies amp and speaker simulation, effects and an additional 3-band EQ.

Use Live Mode 2 to run the V-AMP 3 into the effects return inputs of 2 different guitar amps. This configuration does not feature speaker simulation, allowing the amplifier’s natural speaker sound to go unaltered. In this scenario, the amps would be mic’d on stage to get the sound to the house speakers, and having a dedicated monitor would be less important.

Continued on next page

Laptop	UCA222	V-AMP3	HPS3000
	USB Audio Interface