PRO MIXER VMX100
DIFFERENCE display. When the center LED is lit, the tracks are in sync with each other. When the display moves to the left or right, the corresponding channel is running out of sync. The TEMPO DIFFERENCE and TIME OFFSET displays are only active when the tempi of both channels have been locked as explained above.
To exit the SYNC LOCK or BEAT ASSIST mode, simply press the SYNC LOCK key in both channels again.
2.5 Crossfader section
16
17
The CROSSFADER is used to fade between channels 1 and 2.
The CURVE switch, located on the left side of the CROSSFADER, enables you to select between two crossfade modes: SOFT and SHARP. In SOFT mode the crossfader fades between the channels in a linear, continuous manner. This mode is recommended for slower, smoother crossfades. In SHARP mode the crossfader takes on a more logarithmic effect, working faster towards the outer edges of the fader range. Use this mode for faster, “hard” crossfades.
+Flipping the CURVE switch may cause a sudden change in volume. We recommend not changing this setting while a signal is present.
18The MIC INPUT connector is a balanced ¼" TRS socket for microphone connection.
+We strongly recommend the use of
19The HEADPHONES socket allows you to connect your headphones for
3.REAR PANEL
With the exception of MIC INPUT and HEADPHONES, all of the VMX100’s audio connections are located on the rear panel and supplied as RCA connectors.
Fig 3.1: Rear view of the PRO MIXER VMX100
20The PHONO inputs for channel 1 and 2 are only for turntable connection.
21The LINE inputs may be used for connecting tape decks, CD or MD players etc.
22The GND connection allows grounding of a turntable.
23Use the AMP output to connect the VMX100 to an amplifier. The level is controlled by the MAIN knob in the MIC/MAIN section.
8 | 3. REAR PANEL |