11XENYX QX1202USB/QX1002USB User Manual
3.2Live sound
B215D Active Speakers
XM8500 | Bass Guitar |
|
DI100
F1320D Active Monitors
L
R
FX2000 Eects Processor | Portable | MP3 Player |
| Digital |
|
| Recorder |
|
Fig 3.2: Live performance with the QX1202USB
The above diagram shows some typical connections for a live performance using the QX1202USB. Mono sources such as microphones and
If an external effects processor is to be used instead of the onboard processor, connect the FX SEND jack to the input of your processor. Turn the FX knob up on each channel that you want to add effects to. Connect the outputs (usually stereo) from the processor to one of the stereo channels as shown in the diagram. Make sure to leave the FX knob for this stereo channel fully counterclockwise (off) to avoid feedback loops. Turn the LEVEL knob up on the stereo channel receiving the processed signal to blend the effects into the mix.
Connect the MAIN OUTPUTS to active speakers or a power amplifier. You may also connect active floor monitors to the CONTROL ROOM OUTPUTS so the
4. Installation
4.1 Mains connection
AC POWER IN
Connect the power supply to the
◊Please use only the power supply unit provided with the console.
◊Never connect the XENYX to the power supply unit while the latter is connected to the mains! First connect the console to the power supply unit, then connect the power supply unit to the mains.
◊Please note that both the power supply unit and the mixing console heat up considerably during operation. This is completely normal.