38 Operation
English
Personalizing the On-Screen Display (OSD) menus
The On-Screen Display (OSD) menus can be set according to your preferences. The following settings do not
affect the projection settings, operation, or performance.
•Menu Display Time in the SYSTEM SETUP: Advanced > Menu Settings menu sets the length of time the
OSD will remain active after your last key press. The time length ranges from 5 to 30 seconds in 5-second
increments. Use / to select a suitable time.
•Menu Position in the SYSTEM SETUP: Advanced > Menu Settings menu sets the OSD position in five
locations. Use / to select a preferred position.
•Language in the SYSTEM SETUP: Basic menu sets your familiar language for the On-Screen (OSD) Menus.
Use / to select your language.
•Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be displayed during
projector start-up. Use / to select a screen.
Shutting down the projector
1. Press POWER and a confirmation message displays
prompting you.
If you don't respond in a few seconds, the message will
disappear.
If you want to cancel the message, press any key except
LASER on the remote control.
Do not look into the laser light window or shine the laser
light beam on yourself or others. See the warning
messages on the back of the remote control prior to
using it.
2. Press POWER a second time. The POWER
indicator light flashes orange, the projection lamp
shuts down, and the fans will continue to run for
approximately 90 seconds to cool down the projector.
3. Once the cooling process finishes, a "Power Off Ring
Ton e " will be heard. The POWER indicator light is a
steady orange and fans stop.
4. Disconnect the power cord from the wall socket if the
projector will not be used in an extended period of time.
Lamp life results will vary depending on environmental
conditions and usage.
• To protect the lamp, the projector will
not respond to any commands
during the cooling process.
• To shorten the cooling time, you can
also activate the Quick cooling
function. See "Quick Cooling" on
page 42 for details.
• To turn off the power ring tone, see
"Turning off the Power on/off ring
tone" on page 37 for details.
I
I
I
I
If the projector is not properly
shut down, to protect the lamp, when
you attempt to re-start the projector, the
fans will run for a few minutes to cool
down. Press POWER again to start
the projector after the fans stop and the
POWER indicator light turns orange.
I
I