11
Wait at least ten seconds or until water noises
stop before opening the dishwasher door.
To resume the cycle, press the On/Off button and
shut the dishwasher door.

Selecting the Proper Wash Cycle

Always make sure your dishware is dishwasher
safe. Refer to the Dishware Materials section of
this manual for guidance.
Power Scrub Plus
Cleans items having baked-on or hard dried-on
food soils. These items may require soaking or
hand scouring.
Regular
Thoroughly cleans large loads having loosely
attached normal soiling.
Operating the Dishwasher

Starting the Dishwasher

Open the dishwasher door far enough to expose
the control buttons.
Press the On/Off button.
Press the button for the desired wash cycle.
Shut the dishwasher door.
The dishwasher will start automatically and
continue operating until the end of the selected
cycle.
Once you start the dishwasher, leave the
dishwasher door shut until it finishes the cycle.
To avoid damage to delicate or heirloom
items do not wash them in your dishwasher.
Delicate/Economy
For delicate or heirloom dishware and silverware
or other special items. Always make sure that the
items are dishwasher safe. Refer to the Materials
section of this manual for more information. Hand
washing may be the best treatment of such
items.
Quick Wash
For lightly soiled items with easy to remove food
soils.
Rinse and Hold
Allows you to rinse the food soil off of a partial
load and hold them in the dishwasher until there
is a full load.
More information on dishwasher cycles is located
in the Wash Cycle Information section of this
manual.

WARNING

You could be seriously scalded if you open
the dishwasher door quickly during a wash
or rinse cycle. Do not fully open the
dishwasher door for at least 10 seconds or
until water noises stop.

Interrupting a Cycle

NOTE
: Should you need to interrupt a cycle (to
add or remove an item, to add detergent, etc.), it
is best to do so within the first 30 minutes of the
cycle.
Open the dishwasher door far enough to expose
the control buttons.
Press the On/Off button.
Figure 16
Cancel Drain

Canceling or Changing a Cycle

To cancel or change a cycle, open the
dishwasher door far enough to expose the control
buttons then press and hold for three seconds the
two buttons labeled “Cancel Drain” as shown in
Figure 16.
Shut the door and wait approximately one minute,
then press the On/Off button
You may now begin a new cycle.