Boston Acoustics 1000M, 500M manual Connections / Controls, Connections and Controls, Status LED

Connections and Controls

GTA-500m
1	2	3	4	5	6	7	8	9	10	11
GTA-1000m

1 2 3 4 5 6 7 8 9 10 11

υ	Speaker Level Input
ϖ	RCA Input (Left and Right)
ω	Gain (250mv to 5.0v - continuously variable)
ξ	Q-Tune™“Q” Adjustment (0.707 to 1.6 - cont. variable)
ψ	Lowpass Crossover Adjustment (50Hz to 150Hz - cont.	variable)
ζ	Q-Tune™Highpass (Subsonic) Adjustment (10Hz to 50Hz -	cont. variable)
{	GTA-RSL Port (Remote Gain)
	Speaker Output Block
}	Status LED (Blue = Normal / Red = Fault Mode)
∼	Fuse (Replace with same value only, refer to specifications on page 2)

Power Block (12v / Remote / Ground)

Status LED

The Boston Logo will illuminate “Blue” under normal operating conditions.

The LED will illuminate “Red” during start-up and under fault conditions. If the LED is still red after start-up, please refer to troubleshooting on page 8.

Speaker Level Input Cable

GTA amplifiers offer a dedicated speaker level input for ease installation into factory systems when an RCA (low level) signal is not available. Wiring code for the cable is industry standard;

White Solid = Left Positive	White w/ Black Stripe = Left Negative
Gray Solid = Right Positive	Gray w/ Black Stripe = Right Negative

Warning: Do not connect both Speaker Level and RCAs into the amplifier at the same time as damage to the amplifier may occur.

Connections / Controls

3