The low oil indicator system is designed to prevent engine damage caused from insufficient engine oil. If the engine oil level drops below a preset level, the yellow LED low oil indicator light (Figure 47) illuminates and an oil switch will stop the engine.
Figure 47
4.Test for continuity between ground and the low oil switch (A, Figure 49).
•If continuity is not measured, the switch is good.
•If continuity is measured and the oil level is good, either the switch or the wiring is defective. Repair the wiring or replace the switch.
|
|
|
| A |
|
|
|
| Reproduction |
If the engine will not start and the low oil indicator is | ||||
illuminating, proceed as follows: |
| Figure 49 | ||
1. | Check the oil level in the generator. If level is acceptable, | |||
| proceed to Step 2. | Not |
| |
2. | It is possible that the oil indicator float is stuck. Gently | |||
| rock the generator in a | |||
| float. |
|
|
|
3. | If oil level is correct and the fl | at is n t stuck, remove | ||
| the control panel and disconnect the | |||
| (Figure 48). |
| for |
|
|
|
|
| |
Figure 48
26 | BRIGGSandSTRATTON.COM |