Bobbin Insertion | CAUTION – Moving parts – |
|
To reduce risk of injury, turn the power to the machine off before servicing. Open covers.
1 | Needle Plate |
|
2
Bobbin Door
�Bobbin should be positioned so it winds to the left.
Latch Spring | Quick Bobbin |
| |
| Thread Device |
1
Thread Notch | 3 |
| |
| 2 |
10 cm (4 inches) |
|
1 Lift needle plate and open bobbin door.
2
2 Put bobbin into the bobbin case.
✽✽ Run thread through thread notch and under latch spring, so that a length of thread is exposed.
✽✽ Always use the bobbin case that was supplied with this machine. A secondary bobbin case can be ordered from your dealer.
3 Pull the latch lever of the bobbin case out and push the bobbin case into the shuttle race and release the latch lever.
✽✽ If the latch lever is not set securely on the hook, it may fly off during sewing and cause lower thread breakage.
Rotate the hand wheel one full rotation towards you to check that the bobbin case is set securely.
4 Pass the thread through the quick bobbin thread device in the order 1 2, pull in the direction of the arrow 3, then cut the thread.
★Quick Bobbin Thread Device
This device cuts the bobbin thread end to an appropriate length after the bobbin has been replaced and holds it at that length. Following this process eliminates the need to manually pull the bobbin thread through the hole in the needle
1
5 Lower slide plate and close bobbin door, following numbers 1 2 above in order.
Open the bobbin thread setting cover beforehand, then following the above directions set the bobbin thread in place. (You can set the bobbin thread in place without removing the fabric extension table.)
Bobbin Thread Setting Cover
plate. Simply close the bobbin case and continue the upper threading process.
13