For Wireless Network Users

One push setup using WPS (Wi-Fi Protected Setup) or AOSS™ (Windows® and Macintosh)

11 Configure the wireless settings

a Confirm your wireless access point/router has the WPS or AOSS™ symbol as shown below.

b Place the Brother machine within range of your WPS or AOSS™ access point/router. The range may differ depending on your environment. Refer to the instructions provided with your wireless access point/router.

If you began the wireless setup from step 5 on page 5, go to d.

All other users, go to c.

c On your machine, press a or b to choose Network and press OK.

Press a or b to choose WLAN and press OK.

d Press a or b to choose WPS/AOSS and press OK.

When WLAN Enable? is displayed, press a to accept. This will start the wireless setup wizard.

Otherwise press Cancel to exit from the wireless setup wizard.

e When Press Key on rtr appears, press the WPS or AOSS™ button on your wireless access point/router. See the user’s guide for your wireless access point/router for instructions. And then press a.

Note

If your wireless access point/router supports WPS (PIN Method) and you want to configure your machine using the PIN (Personal Identification Number) Method, see Configuration using the PIN Method of WPS (Wi-Fi Protected Setup) in the Network User's Guide.

f A connection result message appears on the LCD and a WLAN report will automatically be printed.

If the connection failed, check the error code on the printed report and refer to Troubleshooting on page 25.

Wireless setup is now complete. A four level indicator at the right of your machine’s LCD will show the wireless signal strength of your wireless access point/router.

To install the printer driver, continue to step 12.

For Windows® Users:

Now go to

page 28

For Macintosh Users:

Now go to

page 30

This feature will automatically detect which mode (WPS or AOSS™) your wireless access point/router uses to configure your machine.

24