For Wireless Network Users

Connecting the Brother machine to the wireless network

Important

You must have the wireless setting you wrote down for your network in step 24 on page 33 before you proceed.

25 Configure the wireless settings (Typical Wireless Setup in infrastructure mode)

a On your machine, press MENU.

Press a or b to display Network and press Network.

Press WLAN.

Press Setup Wizard.

When Switch Network interface to wireless? is displayed, press Yes to accept. This will start the wireless setup wizard.

To cancel, press No.

b The machine will search for available SSIDs. If a list of SSIDs is displayed, press a or b to choose the SSID you wrote down in step 24 on page 33. Press the SSID you want to connect with. Go to f.

Note

It will take several seconds to display a list of available SSIDs.

If your access point is set to not broadcast the SSID you will have to manually add the SSID name. Go to c.

c Press <New SSID>. Go to d.

d Enter the SSID you wrote down in step 24 on page 33 using the Touchscreen.

You can use the d and c keys to move the cursor left and right.

The letters appear in this order: upper case and then lower case.

To enter numbers or special letters, press repeatedly until the character you want to enter appears.

(For more information, see Entering Text for Wireless Settings on page 49.)

Press OK when you have entered all the characters.

e f

g

Press Infrastructure.

Choose one of the options below: If your network is configured for Authentication and Encryption you must match the settings used for your network.

„No Authentication or Encryption: Press Open System, then press None for

Encryption Type? Then press Yes to apply your settings. Go to i.

„No Authentication with WEP Encryption:

Press Open System, then press WEP for the Encryption Type? Go to g.

„Authentication with WEP Encryption: Press Shared Key. Go to g.

„Authentication with WPA/WPA2-PSK

(TKIP or AES) Encryption: Press WPA/WPA2-PSK. Go to h.

Choose the appropriate key number. Enter the WEP key you wrote down in step 24 on page 33 on the Touchscreen.

You can use the d and c keys to move the cursor left and right.

The letters appear in this order: upper case and then lower case.

To enter numbers or special letters, press repeatedly until the character you want to enter appears.

(For more information, see Entering Text for Wireless Settings on page 49.)

Press OK when you have entered all the characters, then press Yes to apply your settings. Go to i.

34