110
UTILITY STITCHES — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Scallop stitching
The wave-shaped repeating pattern that looks like
shells is called "scalloping". It is used on the collars of
blouses and to decorate the edges of projects.
aAttach monogramming foot "N".
• For details, refer to "Replacing the presser
foot" (page 42).
bSelect stitch 27 .
• For details, refer to "Selecting stitching" (page
49).
cStitch along the edge of the fabric, making sure
not to sew directly on the edge of the fabric.
• For better results, apply spray starch o nto the
fabric and press with a hot iron before it is
sewn.
dTrim along the stitches.
• Be careful not to cut the stitches.
Smocking
The decorative stitch created by stitching or
embroidering over gathers is called "smocking". It is
used to decorate the front of blouses or cuffs.
The smocking stitch adds texture and elasticity to
fabric.
aAttach zigzag foot "J".
• For details, refer to "Replacing the presser
foot" (page 42).
bSelect the straight stitch, and then adjust the
stitch length to 4.0 mm (3/16 inch) and loosen
the thread tension.
• For details, refer to "Adjusting the stitch
length" (page 57) and "Adjusting the thread
tension" (page 57).
• Pull up the bobbin thread. For details, refer to
"Pulling up the bobbin thread" (page 36).
cSew parallel stitching at intervals of 1 cm
(3/8 inch).
a1 cm (3/8 inch)
• Do not use reverse/reinforcement stitching or
thread cutting.
• At the end of the stitching, the thread is
pulled out about 5 cm (2 inches).
dPull the bobbin threads to create gathers.
Smooth the gathers by ironing them.
J
1