11
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Needle and presser foot section
aButtonhole lever
Lower the buttonhole lever when sewing buttonholes
and bar tacks.
bThread guide disk
Pass the thread through the thread guide disk when
using the needle threader to thread the need le.
cNeedle bar thread guide
Pass the upper thread through the needle bar thread
guide.
dNeedle plate
The needle plate is marked with guides for sewing
straight seams.
eNeedle plate cover
Remove the needle plate cover to clean the bobbin case
and race.
fBobbin cover/bobbin case
Remove the bobbin cover, and then insert the bobbin
into the bobbin case.
gFeed dogs
The feed dogs feed the fabric in the sewing direction.
hPresser foot
The presser foot applies pressure consistently on the
fabric as the sewing takes place. Attach the appropriate
presser foot for the selected stitching.
iPresser foot holder
The presser foot is installed onto the presser foot holder.
Right-side/rear view
aHandle
Carry the sewing machine by its handle when
transporting the machine.
bHandwheel
Turn the handwheel toward you (counterclockwise) to
raise and lower the needle to sew one stitch.
cEmbroidery card slot
Insert the embroidery card.
dAir vent
The air vent allows the air surrounding the motor to be
exchanged. Do not cover the air vent while the s ewing
machine is being used.
eMain power switch
Use the main power switch to turn th e sewing machine
on and off.
fFoot controller jack
Insert the plug on the end of the foot controller cable
into the foot controller jack.
gPower supply jack
Insert the plug on the power supply cord into the power
supply jack.
hFeed dog position switch
Use the feed dog position switch to lower the f eed dogs.
iPresser foot pressure dial
Use the presser foot pressure dial to adjust the amount
of pressure that the presser foot applies.
Memo

zRefer to pages 10 through 13 while you are

learning to use your machine.