Wireless Configuration for Macintosh using the Brother installer application (For
l If the LCD shows Connected, the machine has successfully connected to your router or access point. You can now use your machine in a wireless network.
If the LCD shows Connection Error, a session overlap has been detected. The machine has detected more than one access point/router on your network with the SecureEasySetup™ mode, the
If the LCD shows No Access Point, the machine has not detected your access point/router on your network with the SecureEasySetup™ mode, the
If the LCD shows Connection Fail, the machine has not successfully connected to your access point/router. Try starting from i again. If the same message is indicated again, reset the machine back
to the default factory settings and try again. (For resetting, see Restoring the network settings to factory 5 default on page 114.)
LCD messages when using the SES/WPS/AOSS control panel menu
LCD shows | Connection status | Action | |
Setting WLAN | Searching or accessing the access point, |
| |
and downloading settings from the access | — | ||
| point. |
| |
|
|
| |
Connecting SES |
|
| |
Connecting WPS | Connecting to the access point. | — | |
Connecting AOSS |
|
| |
Connected | Connection succeeded. | — | |
|
| Check that only one router or access | |
Connection Error |
| point has the SecureEasySetup™ | |
Session overlap has been detected. | mode, the | ||
|
| mode or AOSS™ mode enabled and try | |
|
| starting from step i again. | |
|
|
| |
No Access Point |
| Move the machine closer to your | |
The access point detection failed. | access point/router and try starting from | ||
|
| step i again. | |
|
|
| |
|
| Try starting from step i again. | |
Connection Fail | The machine was not able to connect with | If the same message reappears, | |
the access point. | reset the machine back to the | ||
| |||
|
| factory settings and try again. | |
|
|
|
84