Buhler 2425, 2335, 2290, 2375, 2360 manual Standard Tie Rod Style Dual Wheels

SECTION 3 - LUBRICATION AND MAINTENANCE

AS REQUIRED

3.Standard Tie Rod Style Dual Wheels

a.It is only permissible to install the inner wheel with the rim inset (narrow tread width). There is no drive lug on the outset side of the wheel.

b.Place a jack under one side of the axle housing. Raise the side and torque the inner wheel mounting nuts, 1, to 710 N⋅m (525 ft. lbs.).

1

c.Place two tie rods, 1, in the outer holes, 2, of the inner wheel 180° apart. Place a flange nut on the back side of the inner wheel disc on each tie rod. The two tie rods will help align the inner and outer wheels during initial assembly.

Figure 3-134

2

1

1

Figure 3-135

d.Install a spacer, 1, into the inside of the inner wheel rim. Be sure the positioning lugs on the inner wheel (one tab) and the spacer (two tabs) interlock.

e.Lightly tap the spacer for a snug fit to the inner wheel. Push the two tie rods in toward the frame so they do not protrude through the spacer.

1

Figure 3-136

3-82