Operating Instructions and Assembly Instructions
Airless Paint Sprayers
Storage
short term
(less than one week)
WEAR ALL NECESSARY
SAFETY GEAR
Necessary Tools / Materials:
•Pump Protector Solution
•Plastic Wrap
•3/4 in. or Adjustable Wrench
Oil or Alkyd Based Paint
If sprayer cleaned with mineral spirits, simply wrap suction filter housing
in plastic to keep debris out of suction filter. No other preparation is necessary.
1.Prepare Pump Protector solution in bucket as directed on container.
2.Place suction assembly into solution.
3.Place end of bypass tube into waste bucket.
4.With prime/spray control in PRIME position, turn pressure to HIGH (completely clockwise).
5.Turn power switch ON. Circulate Pump Protector through bypass tube until bucket of solution is
EMPTY.
6.Turn pressure to LOW (completely counterclockwise).
7.Wrap suction filter housing in plastic to keep debris out of suction filter.
long term
(more than one weeK)
8.Remove high pressure hose and drain. Reassemble high pressure hose to pump.
9.With spray tip attached to spray gun, wrap tip with plastic to protect tip.
Water Based Paint
1 | 2 |
|
Pump |
| |
Protector |
| |
| WASTE | |
| BUCKET | |
| PUMP | |
| PROTECTION | |
| SOLUTION | |
Prepare Pump | Place Suction | |
Assembly in | ||
Protector Solution | ||
Solution | ||
|
4 3 
WASTE | WASTE | |
BUCKET | ||
BUCKET | ||
| ||
PUMP | PUMP | |
PROTECTION | ||
PROTECTION | ||
SOLUTION | ||
SOLUTION | ||
| ||
Place End of Bypass Tube | With Prime/Spray | |
into Waste Bucket | Control in PRIME | |
| Position, Turn |
Pressure to HIGH
(completely clockwise)
6 | 7 |
|
Wrap Suction Filter
Housing in Plastic
Turn Pressure to LOW
(completely counterclockwise)
www.chpower.com
14