Operating Instructions and Parts Manual | CHN70899 |
|
|
Important Safety Information (Continued)
g.Do not disassemble tool.
h.Remove batteries when storing tool for an extended time.
NOTE: Battery temperature will increase during and shortly after use.
Only use new Alkaline replacement batteries [two (2) AAA required]. Do not mix old and new batteries.
Battery shelf life - the included batteries may be in a slightly depleted state or dead depending on how long the product has awaited purchase. Do not return product to store for depleted batteries; please call Campbell Hausfeld at
i.Do not modify or alter the nailer or any nailer parts. Do not use the nailer if any shields or guards are removed or altered. Do not use the nailer as a hammer. Personal injury or tool damage may occur.
Do not use any type of flammable gases or oxygen as a power source for the nailer.
Use filtered, lubricated, regulated compressed air only. Use of a compressed gas instead of compressed air may cause the nailer to explode which will cause death or serious personal injury.
Never use gasoline or other flammable liquids to clean the nailer. Never use the nailer in
the presence of flammable liquids or gases.Vapors could ignite by a spark and cause an explosion which will result in death or serious personal injury.
Do not modify or disable the Work Contact Element (WCE). Do not tie or tape the WCE
or trigger in a depressed position. Death or serious personal injury could result.
Always check that the Work Contact Element (WCE) is operating properly.A nail could
accidentally be driven if the WCE is not working properly. Personal injury may occur.
Do not touch the trigger unless driving nails. 
Never attach air line to nailer or carry nailer while touching the trigger.The tool could eject a fastener which will
result in death or serious personal injury.
Service
a.Tool service must be performed only by qualified repair personnel.
b.When servicing a tool, use only identical replacement parts. Use only authorized parts.
c.Use only the lubricants supplied with the tool or specified by the manufacturer.
Disconnect air supply and release tension from the pusher before attempting to clear jams because fasteners can be ejected from the front of the nailer.
Personal injury may occur.
Air Source
a.Never connect to an air source that is capable of exceeding 200 psi. Over pressurizing the tool is able to result in bursting, abnormal operation, breakage of the tool or serious injury to persons. Use only clean, dry, regulated compressed air at the rated pressure or within the rated pressure range as marked on the tool. Always verify prior to using the tool that the air source has been adjusted to the rated air pressure or within the rated
b.Never use oxygen, carbon dioxide, combustible gases or any bottled gas as an air source for the tool. Such gases are capable of explosion and serious injury to persons.
Air compressors providing air to the nailer should follow the requirements established
by the American National Standards Institute Standard
Save These Instructions
Do Not Discard
The DANGER, WARNING, CAUTION, and NOTICE notifications and instructions in this manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
6www.chpower.com