Campbell Hausfeld EZ5000 Using Your HousePainter, Icon showing Highest Pressure position

Figure 14 - Icon showing Prime position

Operating Instructions & Parts Manual

Step 1 – Priming (Cont.)

Control to the Prime position (see Figure 14). After a

few seconds, the

coating will come up the suction tube

and then out the

for thin materials such as water seals and polyurethanes. The highest pres- sure setting (see Figure 17) is used for heavier coatings like latex paint.

Figure 17 - Icon showing Highest Pressure position

bypass tube. Initially, there will be air bubbles in the paint coming

out of the bypass tube. When you no longer see bubbles, turn the One Touch Control to the Spray position (see Figure 15). If you have any diffi-

2

The best way to

determine the proper setting for your job is to begin with the pressure on the lowest setting and spray on a prac- tice surface. Turn the pressure up gradually and continue to spray test swatches after each adjustment until you no longer see ‘tails’ in the spray pattern (see Figure 18). Using this

Figure 15 - Icon showing Spray posi- tion

culty priming, please see the sugges- tions in the Troubleshooting chart beginning on page 13.

Step 2 – Using Your

HousePainter

Setting The Pressure
A range of pressure		Figure 18 – Good spray pattern
settings on the
		shown in white area of top picture.
HousePainter gives		Bad spray pattern – ‘tails’ – shown in
you the flexibility to		white area of bottom picture.
meet any painting
challenge. Use the	Figure 16 - Icon	method to determine the proper pres-
lowest pressure set-		sure setting will provide the best spray
ting (see Figure 16)	showing Lowest	pattern while minimizing overspray as
	Pressure position

www.chpower.com

8