2-1/2 inch 35° Finish Nailer
Visit us at chpower.com | 1 Close pressure | 2 Attach air |
|
| CHN70600 |
| ||
| regulator, Turn | hose to regulator | |
| ON compressor and | outlet. Adjust | |
Setup Like a Pro | Allow tank to reach | regulator knob so | |
maximum pressure. | outlet pressure is | ||
Easy Setup Guide |
| between 70 psi and | |
| 120 psi. |
| |
|
|
| |
| Projects are easier with |
|
|
|
| Campbell Hausfeld products. |
| 70 | 120 |
|
| psi | psi |
Thank you for deciding to purchase a Campbell Hausfeld product. We are dedicated to providing tools that help you to complete your projects Like a Pro.
NOTICE: To operate this tool you will need
at least a 1 gallon compressor.
© 2009 Campbell Hausfeld/Scott Fetzer | IN727601AV 6/09 |
3 Load fasteners. See manual for further information regarding length and type of fasteners. | 4 Attach coupler on air |
| hose to nailer inlet. |
Nail Pusher
Latch Button
| Pull pusher back | Load nails. | Press pusher latch button and |
| until it latches. |
| allow pusher to ride against nails. |
Screw
Battery Replacement
Always disconnect the tool from the power source when unattended,performing any maintenance or repair, clearing a jam, loading, unloading, or moving the tool to a new location.
Disconnect the tool from air source. Remove screw and battery compartment cover. Insert two (2) new batteries in the proper orientation. Do not mix old and new batteries. Close cover. Replace screw.
Setup Like a Pro | CHN70600 — Air Powered Angle Finish Nailer |