Campbell Hausfeld IN729000AV, SB5240, SB524000 5

150 psi WP

3/8 inch I..D..

SB524000

Operating The Tool (Continued)

3. Use 1/4 inch air hoses with a minimum working pressure of 150 psi.. Use 3/8 inch air hoses for 50 foot run or longer.. For

better performance, install a 3/8 inch quick plug (1/4 inch NPT threads) with an inside diameter of ..315 inch (8mm) on the tool and a 3/8 inch quick coupler on the air hose..

4.Use a pressure regulator on the compressor, with an operating pressure of 0 psi - 125 psi.. A pressure regulator is required to control the operating pressure of the tool between 70 psi and 120 psi..

Single SEQUENTIAL Mode

This mode

requires the

trigger to be pulled

each time a fastener is driven.. The tool can be actuated by depressing the WCE against the work surface followed by pulling the trigger..

The trigger must be released to reset the tool before another fastener can be driven..

Checking the Work Contact Element (WCE)

Check the operation of the Work Contact

Element (WCE) trip mechanism before each use. The WCE must move freely without binding through its entire travel distance. The WCE spring must return the WCE to its fully extended position after being depressed. Do not operate the tool if the WCE trip mechanism is not operating properly. Personal injury may occur.

1. Disconnect the air supply from the tool..

2. Remove all fasteners from the magazine (see Loading/ Unloading)..

3.Make sure the trigger and work contact

element (WCE) move freely up and down without sticking or binding..

4. Reconnect air supply to the tool..

5. Depress the Work

Contact Element (WCE) against the work surface without

pulling the trigger.. The tool must not

operate.. Do not use the tool if it operates without pulling the trigger.. Personal injury may result..

6.Remove the tool from the work surface.. The Work Contact Element (WCE) must return to its original

down position.. The tool must not operate.. Do not use the tool if it operates while lifted from the work surface.. Personal injury may result..

7.Pull the trigger and depress the work contact

element (WCE) against the work surface.. The tool MUST NOT operate..

8.Depress the Work Contact Element (WCE)

against the work surface.. Pull the trigger.. The tool MUST operate..

Recommended Hookup

Quick

Regulator

Quick

Quick Plug

Coupler

Quick Plug Coupler

(Optional)

Air Hose

Lubricator

Filter