Canon D1 - page 17

2-2 Trimmer Setup

Trimmer Setup

Turn on the power switch on the saddle stitcher first, then turn on

the power switch on the host machine (printer).

Trimmer will also be powered on because it is connected to the saddle stitc her.

See the operation manual for the printer and set up the printer.

Contents

Main Structure of the Users Guide Page Important Information Safe Use of Machine WARNING CAUTION Operating Safety Precautions WARNING Caution Label Locations FCC NOTICES NOTICE FCC WARNING CONTENTS Section 1 Before You Begin Section 2 Operating Procedures Section 3 Troubleshooting Section 4 Appendix Before You Begin Page Section Descriptions [1] Infeed Section [2] Trim Section [3] Booklet Lifter Section 1 [4] Booklet Lifter Section 2 [5] Conveyor Section Page Page Page Operation While Trimming Page Page Error Messages Service Call Error WARNING Error Messages 3-3 Error Message Chart Perform the required remedies according to the error indicated on the ho st machine (printer). B Cause of Error Remedy and C4 transport belt unit and hold the C2 handle to reposition Clearing Paper Jams Jam in Trim Section Jam in Booklet Lifter Section 1 Jam in Infeed Section Jam in Conveyor Section Page Specifications Specifications Index B C D E