„Power Lamp Flashes Green and Alarm Lamp Flashes Orange Alternately

The Power and Alarm lamps flash alternately as shown below.

Disconnect the USB cable from the machine, turn the machine off, then unplug the machine from the power supply. Plug the machine back in and turn the machine back on.

If the problem is not resolved, contact your Canon Service representative.

Error Code

Cause

Action

E, 2, 2

The FINE Cartridge

Cancel printing, turn off the machine, then remove the protective material

 

Holder does not move.

from the FINE Cartridge Holder or paper jam that is preventing the FINE

 

 

Cartridge Holder from moving.

 

 

Caution

 

 

Be careful not to touch the components inside the machine. The machine

 

 

may not print out properly if you touch it.

E, 2, x

An error requiring

Turn off the machine, and unplug the power plug of the machine from the

E, 3, x

servicing might have

power supply. Then, plug the power plug of the machine back in, and turn

E, 4, x

occurred.

on the machine again. If the same error occurs, contact your Canon

 

Service representative.

 

 

LED Cannot Be Seen At All

 

 

 

Cause

Action

The machine is not powered on or the

z If the Power lamp is off

LED is in the screen-saver mode.

The machine is not powered on. Connect the power plug and press the ON

 

 

button. The machine will power on and the LED will light.

 

z If the Power lamp is lit

 

The LED may be in the screen-saver mode. On the Operation Panel, press a

 

button other than the ON button.

46Troubleshooting