2-9
Step 2 Connect the Camera to the Network
Initial Setting and Installation of Camera
Use of External Power Supply Connect the bundled power interface cable (WP500-VB) as shown below.
Use a 12-VDC or 24-VAC power supply insulated from 100 VAC.·
12 VDC can be connected in a non-polar condition.
Use the power supply within the following voltage range.
24 VAC: Voltage fluctuation within 24 VAC±10%
(50 or 60 Hz within ± 0.5 Hz)
Current supply capacity per camera 0.23 A
12 VDC: Voltage fluctuation within 12 VDC±10%
Current supply capacity per camera 0.36 A
* If a 12-VDC battery power supply is used, be sure to connect a resistor of 0.5 to 1.0Ω/20 W
or more to the power line.
Applicable wires and recommended power cable length This completes the network connection.
Applicable cable (AWG)
Conductor size (
Φ
mm,
Φ
inch)
#18
(single wire
Φ
1.0 mm
(
Φ
0.0039 in), stranded wire
Φ
1.2 mm (
Φ
0.0047 in))
#16
(single wire
Φ
1.3mm
(
Φ
0.051 in), stranded wire
Φ
1.6mm (
Φ
0.063 in))
Maximum cable length, 12 VDC (m (ft))
23 (75.5) 32 (105.0)
Maximum cable length, 24 VAC (m (ft))
46 (150.9) 64 (210.0)
Use a UL cable (UL-1015 or equivalent) for wiring 12 VDC or 24 VAC.
Stripping length
AC adapter
Power interface cable
Approx. 5 mm (0.20 in)
Screwdriver
Tightening torque:
0.4N·m (3.54lbf·in) (max.)