2- 36
Printing with Cut Sheets
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
Loading Cut Sheets
Follow this procedure to set a cut sheet on the platen.
First, if there is a cut sheet on the platen, remove it.
Important
zWhen loading cut sheets that are longer than 914 mm
(36”), the trailing edge of the sheet will touch the floor
and may become dirty. When you set such a long cut
sheet, before you start the print job remove the roll
holder and spread a cloth or some paper on the floor,
or when the cut sheet starts to feed, tuck the trailing
edge into the output stacker.
Note
zThe platen may be fouled with ink so clean inside the
upper cover before you switch to printing on a large
size. (→ P.4 - 11 )
zFor more details about cut sheets that can be set on
the platen, please refer to “Media You Can Use” (→
P.2 - 2 ).
zThe printhead may rub the surface of the curled media,
so try to correct the curl.
1
Open the upper cover and push the release
lever toward the rear.
Important
zDo not touch any areas other than those indicated.
Your hands could get dirty or this could damage the
printer.