Canon ZR400 List of Messages, Memory Card Related Messages

List of Messages

Message	Explanation
SET THE TIME ZONE,	You have not set the time zone, date and time. This message	22
DATE AND TIME	appears each time you turn the power on until you set the time
	zone, date and time.
CHANGE THE BATTERY	Battery pack is exhausted. Replace or charge the battery pack.	13
PACK
THE TAPE IS SET FOR	Cassette is protected. Replace the cassette or change the	135
ERASURE PREVENTION	position of the protect switch.
REMOVE THE	Camcorder stopped operating to protect the tape. Unload and	16
CASSETTE	reload the cassette.
CHECK THE INPUT	DV cable or USB cable is not connected, or the connected digital	81
	device is turned off.
CONDENSATION HAS	Condensation has been detected in the camcorder.	132
BEEN DETECTED
TAPE END	Tape reached the end. Rewind the tape or replace the cassette.		–
CHECK THE CASSETTE	You attempted to perform audio dubbing on a tape recorded in a	83
[REC MODE]	mode other than the SP mode.
CHECK THE CASSETTE	You attempted to perform audio dubbing on a tape recorded in 16-	83
[AUDIO MODE]	bit or 12-bit 4-channel sound.
CHECK THE CASSETTE	You attempted to perform audio dubbing on a tape with a blank	83
[BLANK]	section.
CHECK THE CASSETTE	You attempted to perform audio dubbing on a tape recorded in HD		–
[WRONG FORMAT]	format.
WRONG FORMAT	You attempted to play back a tape recorded in HD format.		–
PLAYBACK NOT
POSSIBLE
COPYRIGHT PROTECTED	You attempted to play back a copyright protected tape.	80
PLAYBACK IS RESTRICTED
COPYRIGHT	You attempted to dub a copyright protected tape. May also appear	80
PROTECTED DUBBING	when an anomalous signal is received during analog line-in
RESTRICTED	recording, or during analog-digital conversion of a copyright
	protected tape.
Memory Card Related Messages

Message		Explanation
NO CARD	Memory card not is inserted into the camcorder.			87
THE CARD IS SET FOR	SD Memory Card is set for erasure prevention. Replace the card			87
ERASURE PREVENTION	or change the position of the protect switch.
NO IMAGES	No images are recorded on the memory card.				–
CARD ERROR	A memory card error occurred. The camcorder cannot record or				–
	play back the image.
	The error may be temporary. If the message disappears after 4
	seconds and “	” flashes red, turn the camcorder off, remove
	the card and reinsert the card. If “		” changes to green, you can
	continue recording/playback.
CARD FULL	No remaining capacity on the memory card. Replace with another				–
	card or erase images.
NAMING ERROR	File or folder number has reached the maximum value.			90

128