MA1202-EAÚ #!3)/ #/-054%2 #/ #,4$

Operation Guide 5298

∙Your watch may differ somewhat from the one shown in the illustration.

∙Some models may use a combination of hands and rotating disks to indicate information. The word “hand” in this section is used to mean both analog hands and rotating disks.

24 Hour Hand

 

Hour Hand

Minute Hand

 

 

A

Click 2

Stopwatch Minute Hand

Click 1

 

 



 

Second Hand

 

 

 

B

 

 

Crown

 

Stopwatch Second Hand

Day Indicator

 

Using the Stopwatch

The stopwatch measures elapsed time in 1-second increments up to 29 minutes, 59 seconds.

Elapsed time

 

 

 

 

 

 

 

A

 

A

 

A

 

A

 

B

Start
Stop
Re-start

Stop

Reset
Important!

Do not operate the stopwatch with the crown pulled out.

Note

An elapsed time operation will stop automatically at the end of 30 minutes.

Correcting the 0 Positions of the Hands

Stopwatch functions

Perform the following procedure if the stopwatch hands do not return to their 0 (zero) positions when you reset the stopwatch.

Pull the Crown out to Click 2.

To adjust the time setting

When the second hand is at

12 o’clock, pull the Crown out to Click 2.

Rotate the Crown to change the time setting.

Push the Crown back in.

Note

∙Take care that you set the correct AM or PM time.

∙When changing the time, move the minute hand four or fi ve minutes past your fi nal setting, and then back it up to the setting you want.

To change the day indicator setting

Pull the Crown out to Click 1.

Rotate the Crown to set the day.

Push the Crown back in.

Note

∙The day indicator setting uses a 31- day month. Make adjustments for months of shorter lengths.

∙Avoid changing the day indicator setting between the hours of 9 p.m. and 1 a.m. Otherwise, the day indicator may not change correctly at midnight.

Use A (clockwise) and B (counterclockwise) to move the Stopwatch Second Hand and Stopwatch Minute Hand to 12 o'clock.

∙Holding down either button will move the second hand at high speed, until you release the button.

∙The Stopwatch Minute Hand is syncronized with the Stopwatch Second Hand .

After all of the hands are the way you want, push the Crown back in.

Important!

Timekeeping stops while the crown is pulled out. Correct the current time setting after performing the above operation.

Specifications

Accuracy: ±20 seconds average per month

Crown Operations

Some water-resistant models (100 meters, 200 meters) have a screw-in crown. When you need to perform a crown operation, rotate it towards you to unscrew it. Then pull the crown out. Avoid applying undue force when pulling. The watch loses its water resistance while the crown is unscrewed. After performing a crown operation, fully screw the crown back in.

If your watch has a rotary bezel...

You can rotate the bezel to align its ▼ mark with the minute hand. Then you will be able to tell how much time has elapsed since aligning the ▼ mark.

Crown

Loosen

Start

Elapsed time

Stopwatch: Measuring Capacity: 29'59" (30 minutes) Measuring Unit: 1 second Measurement: Elapsed time

Battery: One silver oxide battery (Type: SR621SW)

Battery Life: Approximately 2 years (30 minutes stopwatch operation per day)

Current

1