13.Use [8] and [2] to select the second control panel option from the bottom (Trigger Sense).

14.Use [4] and [6] to select the subject movement sensitivity, and then press [SET].

•You can select any one of three sensitivity levels: “High”, “Normal”, or “Low”.

•Move Out CS Setting Guide

High: For a subject that moves out of the boundary quickly

Low : For a subject that moves out of the boundary slowly

•Move In CS Setting Guide

High: For a subject that moves into the boundary quickly or for a small subject (relative to the boundary)

Low : For a subject that moves into the boundary slowly or for a large subject (relative to the boundary)

.To shoot using Move Out CS

1.Compose the image so the subject is within the boundary on the monitor screen.

2.Half-press the shutter button.

•The camera will adjust exposure and focus automatically.

3.When the boundary on the monitor screen turns green, press the shutter button the rest of the

way down.

At this time the camera will go into recording standby and start pre-recording images and storing them in a buffer, in accordance with the Prerecord CS shots setting you configured in step 11 under “To setup the

camera” on page 75. After the buffer becomes full, new images keep being added while older images are continually being deleted.

The camera will start saving images automatically the moment it detects that the subject has moved out of the boundary.

•“0 AUTO” flashes on the monitor screen during recording standby and auto recording.

77

Using BEST SHOT