Casio KL-7200E Error Messages/Display Messages, ∙ Tape Cutting, ∙ Using Labels, SET, ESC, Page, Page, Page, Page, E-24, Action, Action, Action, Action, Action, Message

Ink ribbon is being fed from the tape outlet along with the tape.

Possible Causes	Action	Page
Ink ribbon cassette	Remove the ink ribbon cassette and
loaded while the ink	check to make sure the ink ribbon is
ribbon is slack.	not broken. Next, take up any slack
	in the ink ribbon and then reload the
	tape cartridge.

	Important!	E-7
	∙ Before loading an ink ribbon
	cassette into the label printer,
	always make sure you take up any
	slack in the ink ribbon first.
	∙ If the ink ribbon is broken, you
	must change to another ink ribbon
	cassette.
∙ Tape Cutting
	Cannot cut tape.
Possible Causes	Action	Page
Tape cutter blade is dull.	Take the label printer to the dealer
	from whom you purchased it to have	—
	the tape cutter blade replaced.
Printed text is cut off by tape cut operation.
Possible Causes	Action	Page
The printer is set up for	Be sure to press the FUNC FEED key
manual tape feed.	before performing the tape cut
	operation.
	Important!	E-17
	When the printer is set up for manual
	tape feed, the tape is not fed
	automatically after printing is complete.
Out of tape	Replace the tape cartridge with a new	E-7
	one.

∙ Using Labels

Label will not adhere to a surface.

Possible Causes	Action	Page
The backing paper is still	Peel the backing paper from the back	E-16
on the back of the tape.	of the tape to expose the adhesive.
Surface is unsuitable for	Labels do not adhere well to surfaces	E-16
affixing a tape.	that are rough, wet, oily, or dirty.

Error Messages/Display Messages

Message	Possible Causes	Action
¥ ERROR!	∙ The number carriage	∙ Use wider tape or reduce
	returns you input causes	the number of lines.
* This message
	the label to exceed the	6mm tape...1 line
appears on the	maximum number of lines	9mm tape...1 line
screen for about	for the tape you are	12mm tape...Up to 2 lines
one second.	using.	18mm tape...Up to 3 lines
		24mm tape...Up to 3 lines
NO DATA	∙ You are attempting to
* This message	recall text from memory
	when there is none
appears on the
	stored.
screen for about
one second.
OVERWRITE?	∙ You are attempting to	∙ Press SET to overwrite
	store text in memory	the existing text with the
	when it already contains	new text, or ESC to
	text.	cancel the store
		operation.

E-24