RECHARGEABLE HEADLIGHT HL-EL340RC

ENG

Pat. and Design Pat. PendingCopyright© 2011 CATEYE Co., Ltd. EL34RC-110221 066640702 1
INTRODUCTION

Before using the light, please read this manual and the attached “NiMh Batteries” thoroughly, and keep them for future reference.

FOR SAFE OPERATION
Do not place it within children’s reach.

In preparation for unexpected battery shutoff, we recommend you carry a spare battery.

If the light unit or parts become dirty with mud, etc., clean with a soft cloth which is moistened with mild soap. Never apply paint thinner, benzine or alcohol; damage will result.

Mount the light unit more than 10 cm away from the wireless meter. When it is mounted too close, the transmission may be affected adversely.

This product has waterproof features that allow you to use it in light rain (ANSI/ NEMA FL1). Do not use it in heavy rain.

Operate the switch after you stop your bicycle.
Before Initial Use

The rechargeable battery supplied is charged enough to check the light. Be sure to install it to the light and charge it before use, according to the instructions “How to charge.”

COMPONENTS
HOW TO USE
1Lighting (lighting pattern selection)
The ON/OFF and lighting pattern are selected using a switch.

 

Switch
Standard continuous lighting time
ON OFF: Long press

Hi

: About 9 hours
Hi Low: Single pressLow: About 20 hours
Flash: Quick double press

Flash

: About 80 hours

*When returning from Flash to ON (Hi or Low), it returns to the ON mode used previously.

 

1 sec.

 

OFF

ON(Hi)

 

1 sec.

 

 

 

Double press

 

 

Hi

Switch
Flash

Double press

 

 

 

Low
Remaining battery capacity

When the switch (indicator) lights up red, the battery is almost shutoff. Charge or replace the battery as soon as possible.

Light unit
H-34N Bracket
RechargeableBattery charger (Various forms ac-

 

 

battery x 2cording to the specifications)
HOW TO INSTALL BATTERY
In place of rechargeable batteries, AA bat-

1

2

teries can be used for this light.

 

 

1 Slide the cover backward, while

 

 

pressing down the dot section on

 

 

the top of the unit.

 

How to remove batteries
2 Replace batteries according to the

 

 

marks on the unit, and replace the

 

Dot section
cover.

 

 

CAUTION!:

• Do not use a dry battery (primary battery) together with a rechargeable battery.

Do not use a new battery in combination with an old battery.
• Be sure to install batteries in the correct direction.

• Remove and store batteries when you will not use the light for a long period of time.

2How to charge
DANGER!!:
Charge jack cover
• Do not to charge when dry batteries

 

are installed.

• Be sure to use CatEye rechargeable battery and battery charger. The battery charger is indoor use only.

Commercially available rechargeable batteries should be charged with a compatible battery charger.

1Open the charge jack cover at the back
of the light unit to connect the battery charger plug.

2 Plug the battery charger to an AC outlet. When the switch (indicator) lights up red, charging starts.

* When the switch flashes red, it indicates a charge error. Disconnect the plug, and charge again.

3When the switch red light turns off, charging is completed. Remove the plug, and close the charge jack cover.

To AC power outlet
Battery charger
Otherwise, batteries may leak liquid, which may result in failure.
HOW TO MOUNT
1 Wind the bracket strap around the handlebar, and put
Bracket

 

the strap through the opening.
Rubber pad

1

2 Screw the dial into the bracket to secure it temporarily.

 

 

 

* Insert the light unit to the bracket until it clicks, and

 

 

adjust the beam angle. (Refer to “HOW TO MOUNT

 

 

THE LIGHT”)

 

 

3 Securely tighten the dial, and cut off any excess

 

 

bracket strap.

 

 

* To remove the light unit, pull out it forward while pressing
Strap

 

the button.

 

* To re-adjust the beam angle, loosen the dial enough

 

 

to move the bracket, and securely tighten it after
Dial

 

adjustment.

2

 

CAUTION!:

 

 

• Be sure to tighten the dial by hand. When you tighten

 

 

it too hard with a tool, the screw thread may be

3

 

stripped.

 

• Check the dial and screw (*1) on the bracket periodi-

 

 

cally, and use them without any loosening.

 

 

• Round off the cut edge of the bracket strap to prevent

 

 

injury.

 

 

HOW TO MOUNT THE LIGHT

 

 

*1

Release button
Screw
Switch (indicator) state
Standard charging time
ON : Charging OFF : Charging is completedApprox. 8 hours
Flash : Charge error

 

*Charging and lighting times are approximate values, and will vary by environmental and user conditions.

SPARE PARTS

5338827N

UL : 5341880

5341890

H-34N Bracket

UK : 5341881
Special nickel-hydride

 

EC : 5341882
rechargeable battery x 2

 

AS : 5341884
(Ni-MH 2.2Ah GP220AAH)

 

CHA-2.2AH-2.4V

 

SPECIFICATIONS

 

 

Light source..........................................Phi-5 white LED x 1

 

Battery ..................................................AA Ni-MH 2.2Ah (GP220AAH) rechargeable battery x 2, or AA alkaline battery x 2
Battery charger .....................................CHA-2.2AH-2.4V (Only the rechargeable batteries supplied can be used.)
Operating time (Alkaline battery)...........Hi : Approx. 9 hours (Approx. 7 hours), Low : Approx. 20 hours (Approx. 20

 

hours), Flash : Approx. 80 hours (Approx. 100 hours)
Standard charging time.........................Approx. 9 hours

 

Temperature range................................Charging : 41˚F – 104˚F (5˚C – 40˚C)

 

 

Operating : 14˚F – 104˚F (-10˚C – 40˚C)

 

Recharge/discharge number of times ...About 300 times (until the rated capacity drops to 50%)
Dimensions/weight ...............................4-7/32” x 2-7/64” x 1-59/64” (107 x 53.5 x 49 mm) / 4.87 oz (138 g) (Including

 

rechargeable batteries supplied)

 

*The specifications and design are subject to change without notice.

 

LIMITED WARRANTY

2-year Warranty: Light unit / Battery charger (Deterioration of the battery is excluded.)

CatEye products are warranted to be free of defects from materials and workmanship for a period of 2 years from original purchase. If the product fails to work during normal use, CatEye will repair or replace the defect at no charge. Service must be performed by CatEye or an authorized retailer. To return the product, pack it carefully and enclose the warranty certificate (proof of purchase) with instruction for repair. Please write or type your name and address clearly on the warranty certificate. Insurance, handling and transportation charges to CatEye shall be borne by person desiring service. For UK and REPUBLIC OF IRELAND consumers, please return to the place of purchase. This does not affect your statutory rights.

CO.,LTD.
2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546-0041 JapanService & Research Address for USA
Attn: CATEYE Customer Service SectionCATEYE Service and Research Center
Phone

: (06)6719-6863

1705 14th St. 115 Boulder, CO 80302
Fax

: (06)6719-6033

Phone

: 303.443.4595

E-mail: support@cateye.co.jpToll Free: 800.5CATEYE
URL: http://www.cateye.co.jp

Fax

: 303.473.0006

 

 

E-mail: service@cateye.com

 

 

URL

: http://www.cateye.com