H S I L G N E

A S S E M B LY

For proper stand assembly, follow the

❃ Model 10-450 & 10-460 Series Stand

instructions for your model.

Assembly:

 

❃ Model 10-440 Series Stand Assembly:

1 Insert cross braces into side of leg with

Large

larger hole and secure with screws.

Hole Side

1 Using screws, attach four (4) cross

Do not over tighten.

 

 

 

braces to one set of curved legs.

CAUTION: Inserting cross braces

 

Do not over tighten screws.

in wrong side of leg (small hole side)

 

 

 

 

can cause cross braces to break

Cross

 

 

 

during use.

Brace

Cross

 

 

Brace

2 Using screws, attach four (4) cross

 

 

 

 

 

 

 

 

braces to second curved leg section

 

 

 

 

with screws.

 

 

 

 

CAUTION: Make sure cross braces

 

 

 

 

go into side of leg with larger

 

 

 

 

hole.

 

2 Using screws, attach four (4)

 

 

cross braces and spacers to

 

 

second curved leg section.

3 Hook one end of rod over

Rod

 

 

 

small indentation at end of cross brace (A).

A

3 With casters on floor, insert

Cradle

 

ends of Cradle Support Rod

 

Support Rod

 

through holes in top of

 

 

 

curved leg section.

4 Hook end of rod over opposite

Rod

NOTE: Curved edge of

side of cross brace (B).

B

Cradle Support Rod must be

 

 

angled outward as shown.

Repeat steps 3 & 4 for opposite

 

 

 

 

end.

 

4 Screw knobs over ends of

 

 

Cradle Support Rod

 

 

until knob is tight against legs.

 

 

Hand tighten only.

 

 

Repeat steps 3 & 4 for second curved leg section.

5 With casters on floor, insert ends of Cradle Support Rod through holes in top of curved leg section. NOTE: Curved edge of Cradle Support Rod must be angled outward as shown.

Make sure rod installed in steps 3 & 4 remains hooked on cross braces before securing cradle supports.

6 Screw knobs over threaded ends of Cradle Support Rod until knob is tight against legs. Hand tighten only.

Cradle

Support Rod

3

Repeat steps 5 & 6 for opposite end.