![](/images/backgrounds/52465/52465-4025x1.png)
All
Please read and comply with the warnings and reinforcement instructions on page 24. They apply to
Header Wall | — Finished Ceiling — |
|
2x4 Support
Header
Bracket
DoorOptional
Bracket Placement
of Door
Bracket
Vertical
Centerline of
Garage Door
Horizontal and vertical
reinforcement is needed for
lightweight garage doors (fiberglass, aluminum, steel, door with glass panel, etc.).
Nut |
| |
Lock Washer | ||
| 5/16" | |
Door | Top of Door | |
Bracket | ||
| (Inside Garage) | |
| Top Edge | |
| of Door | |
| Optional | |
| Placement | |
For a door with no |
| |
exposed framing or for | Carriage Bolt | |
the optional installation, | ||
use | ||
| ||
screw (not supplied) to |
| |
fasten door bracket. |
|
•Center the bracket on the top of the door, in line with the header bracket as shown. Mark holes.
•Drill 5/16" pilot holes and fasten the door bracket with hardware supplied.
If the door has no exposed framing, drill 3/16" pilot holes and fasten the bracket with
The door bracket may be installed on the top edge of the door if required for your installation. (Refer to the dotted line optional placement drawing.) Drill 3/16" pilot holes and substitute
Hardware Shown Actual Size
Nut | Lock Washer 5/16" |
Carriage Bolt
25