PROGRAMMING

NOTICE: If this Security✚® garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical measure.

Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will open and close when you press the large push button.

Below are instructions for programming your opener to operate with additional Security✚® remote controls.

To Add or Reprogram an Additional Hand-held Remote Control

USING THE “LEARN” BUTTON

123

12

1. Press and release the “learn”

1

2

button on the motor unit. The

 

 

learn indicator light will glow

 

 

steadily for 30 seconds.

 

 

KG

2. Within 30 seconds, press and hold the button on the hand-held remote* that you wish to operate your garage door.

3. Release the button when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks will be heard.

To Erase All Codes From Motor Unit

Memory

1

2

To deactivate any unwanted remote,

 

first erase all codes:

 

Press and hold the “learn” button on

KG

motor unit until the learn indicator light

 

goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use.

*3-Button Remotes

If supplied with your

garage door opener, the large button is factory programmed to operate

it. Additional buttons on any Security✚® 3-button remote or mini-remote

can be programmed to operate other Security✚® garage door openers.

35