Chamberlain 2565 owner manual

The Chamberlain Group, Inc.

845 Larch Avenue

Elmhurst, Illinois 60126-1196

www.chamberlaingroup.com

GARAGE DOOR OPENER

Model 2565 1/2 HP

For Residential Use Only

Owner’s Manual

■Please read this manual and the enclosed safety materials carefully!

■Fasten the manual near the garage door after installation.

■The door WILL NOT CLOSE unless the Protector System®is connected and

properly aligned.

■Periodic checks of the opener are required to ensure safe operation.

■The model number label is located under the light lens on the left side

panel of your opener.

Contents

Main GARAGE DOOR OPENER Model 2565 1/2 HP For Residential Use Only Owners Manual Introduction Pages 2-5 Assembly Pages 6-7 serious injury or death Installation Pages 7-23 TABLE OF CONTENTS Mechanical Electrical INTRODUCTION Safety Symbol and Signal Word Review Preparing your garage door Tools needed SECTIONAL DOOR INSTALLATION Planning ONE-PIECE DOOR WITH TRACK FINISHED CEILING Support bracket & fastening hardware is required. See page 13. Slack in chain tension is normal when garage door is closed. ONE-PIECE DOOR WITHOUT TRACK Carton Inventory ASSEMBLY STEP 1 Attach the T-Rail to the Motor Unit Proceed to Assembly Step 3. ASSEMBLY STEP 2 Attach the Chain to the Sprocket and Install the Sprocket Cover IMPORTANT INSTALLATION INSTRUCTIONS To reduce the risk of severe injury or death: INSTALLATION STEP 1 Determine the Header Bracket Location Proceed to Step 2, page 10. Proceed to Step 2, page 10. INSTALLATION STEP 2 Install the Header Bracket INSTALLATION STEP 3 Attach the T-Rail to the Header Bracket INSTALLATION STEP 4 Position the Opener INSTALLATION STEP 5 Hang the Opener INSTALLATIONSTEP 6 Install the Door Control (Standard installation only) INSTALLATION STEP 7 Install the Lights INSTALLATION STEP 8 Attach the Emergency Release Rope and Handle INSTALLATIONSTEP 9 Electrical Requirements INSTALLATION STEP 10 Install The Protector System Garage door track installation (preferred): Wall installation: Floor installation: glow steadily sending receiving eye INSTALLATION STEP 11 Fasten the Door Bracket Metal, insulated or light weight factory reinforced doors: Wood Doors: NOTE: The 1/4"-14x5/8" self-threading screws are not intended for use on wood doors. Metal Doors: Wood Doors: INSTALLATION STEP 12 Connect Door Arm to Trolley Figure 1: Figure 2: Figure 3, Hole alignment alternative: 1.Assemble the door arm: 2.Adjustment procedures: 3.Connect the door arm to the trolley: ADJUSTMENT STEP 1 Adjust the UP and DOWN Travel Limits ADJUSTMENT STEP 2 Adjust the Force 1.Test the DOWN (close) force Do not increase the force beyond the minimum amount required to close the door. Test the UP(open) force ADJUSTMENT STEP 3 Test the Safety Reversal System ADJUSTMENT STEP 4 Test the Protector System OPERATION IMPORTANT SAFETY INSTRUCTIONS Securitylight feature: The opener lights The Keyless Entry (See Accessories): The wall-mounted Door Control: To Open the Door Manually Automatic Light Feature, lockout feature Using the Wall-Mounted Door Control Light feature CARE OF YOUR OPENER Having a Problem? Installation Step 6 1. The opener doesn't operate from either the Door Control or the remote control: 2. Opener operates from the remote, but not from the Door Control: Having a Problem? (Continued) *3-Channel Remotes To Erase All Codes From Motor Unit Memory To Add an Additional Hand-held Remote Control USING THE LEARN BUTTON USING THE MOTION DETECTING DOOR CONTROL PROGRAMMING To Add or Change a Keyless Entry PIN To change an existing, known PIN To set a temporary PIN REPAIR PARTS Page ACCESSORIES LIFTMASTER GARAGE DOOR OPENER FIVE-YEAR LIMITED WARRANTY LIFTMASTER SERVICE IS ON CALL 1-800-528-2817 HOW TO ORDER REPAIR PARTS