The receiver can be used with a
INSTALLATION
The receiver and antenna use TV Type F coaxial connectors. The antenna can be plugged directly into the receiver or mounted to a bracket and connected to the receiver with Model 86 Coaxial Cable Kit, depending on your requirements.
Select a location for the receiver which allows access to the terminals and space for the antenna (as far from metal structures as possible and preferably with the antenna in an upright position). Fasten the receiver securely with screws through the two holes provided in the cover flanges.
To use the receiver with a 3-button door control and a commercial door opener:
Consult your manufacturer’s control connection diagram for instructions on connecting two or more
• Use a screwdriver to pry open the receiver cover.
NOTE: The slide switch is factory set to the N.C. position (other- wise the opener will not operate). Verify this setting.
3-Channel Receiver
Model 323LM
OWNERS MANUAL
WARNING
To prevent possible SERIOUS INJURY or DEATH from electrocution:
• Be sure power is not connected BEFORE installing the receiver.
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
•ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters.
•Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.
•ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.
WARNING
To prevent possible SERIOUS INJURY or DEATH, the use of CONSTANT OPERATION on residential openers is PROHIBITED.
WARNING
When a receiver is used to activate a commercial door opener, a reversing edge MUST be installed on the bottom of the door. Failure to install a reversing edge under these circumstances may result in SERIOUS INJURY or DEATH to persons trapped beneath the door.
Figure 1 | Example of Operator |
|
|
|
| Terminal Strip |
|
|
|
COAXIAL |
|
|
|
|
RECEIVER |
|
| Figure 2 |
|
|
|
| Connect | |
| 24Vac | CONTROL |
| Antenna |
1 | OPENING RECEIVER |
| ||
| STATION |
| ||
C(Blue) |
|
| ||
2 |
|
|
|
|
B(Yellow) | STOP | OPEN |
|
|
3 |
|
|
| |
|
|
|
| |
A(Grey) | Wire nut |
|
| C |
4 |
| CLOSE |
| B |
|
|
|
| |
| COMMON |
|
| A |
|
| STOP |
|
|
Close
Open
Stop
CLOSE
OPEN
Slide Switch – N.C. Position
•Select a remote control push button to STOP the opener. (It is recommended that you use the large button on remote).
•Press and hold the selected remote push button.
•Then press and release the “learn” button labeled “A” on the receiver. The adjacent indicator light will FLASH.
•Release the remote push button.
Repeat the procedure above with a second remote push button and receiver “learn” button “B” to program the OPEN operation; and again with the last remote push button and receiver “learn” button “C” to program the CLOSE function of the opener.
Return the front cover to the receiver.
NOTE: If a remote control push button is not pressed within 30 seconds, the indicator light adjacent to the selected “learn” button will turn OFF. In that case, repeat the programming.
1