19
INSTALLATION STEP 7

Install the Light and Lens

INSTALL THE LIGHTS
•Install a 75 watt maximum light bulb in the socket.
The light will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the light will turn OFF.
•Use standard neck Garage Door Opener bulbs for
replacement.
INSTALL THE LENS
The Force Adjustment control and “learn” button are
located on the back panel. For convenience, you
may wish to install the lens after installation and
adjustment procedures are completed.
•Slide lens into guides. Snap bottom tabs into lens
slots.
•Reverse the procedure to remove the lens.
INSTALLATION STEP 8

Attach the Emergency Release

Rope and Handle

•Thread one end of the rope through the hole in the
top of the red handle so "NOTICE" reads right side
up as shown. Secure with an overhand knot at
least 1" from the end of the rope to prevent
slipping.
•Thread the other end of the rope through the hole
in the release arm of the outer trolley.
•Adjust rope length so the handle is 6 feet above
the floor. Secure with an overhand knot.
NOTE: If it is necessary to cut the rope, heat seal
the cut end with a match or lighter to prevent
unraveling.
• To prevent possible SERIOUS INJURYor DEATH from
a falling garage door:
– If possible, use emergency release handle to
disengage trolley ONLYwhen garage door is
CLOSED. Weak or broken springs or unbalanced
door could result in an open door falling rapidly
and/or unexpectedly.
– NEVER use emergency release handle unless garage
doorway is clear of persons and obstructions.
• NEVER use handle to pull door open or closed. If rope
knot becomes untied, you could fall.
Lens
Guide
Lens
Tab
Lens
Slot
75 Watt
(Maximum)
Light Bulb
(Model 7220
Only)
Trolley
NOTICE
Overhand
Knot
Emergency
Release Handle
Rope
Trolley
Release Arm
WARNING
CAUTION
WARNING
WARNING
ATTENTION
AVERTISSEMENT AVERTISSEMENT
AVERTISSEMENT