Operation of Your Opener
Activate the opener with any of the following:
•The Remote Control Transmitter. Hold the large push button down until the door starts to move.
•The Door Control. Hold push bar down until the door starts to move.
•The Outside Keylock or Keyless Entry. (See Accessories)
When the opener is activated with the safety reversing sensor installed and correctly aligned:
1. If open, the door will close. If closed, it will open.
WARNING
Weak or broken springs could allow an open door to fall (either rapidly or unexpectedly), resulting in serious injury, death or property damage. If possible, use the manual release rope and handle only when the door is fully closed.
2.If closing, the door will reverse.
3.If opening, the door will stop (allowing space for entry and exit of pets and for fresh air).
4.If the door has been stopped in a partially open position, it will close.
5.If obstructed while closing, the door will reverse.
6.If obstructed while opening, the door will stop.
7.The garage door will reverse in the closing cycle, and the opener lights will blink for 5 seconds, when the invisible beam is broken. If fully open, the door will not close when the beam is broken. The sensor has no effect in the opening cycle.
Trolley
Trolley
ReleaseArm
(in Manual
Disconnect
Position)
NOTICE
Lockout position
(Manual disconnect)
To open the door manually: The door should be fully closed if possible. Pull down on the manual release handle (so that the trolley release arm snaps into a vertical position) and lift the door manually. The lockout feature prevents the trolley from reconnecting auto- matically, and the door can be raised and lowered manually as often as necessary.
If the sensor is not installed, or is not aligned correctly, the door won't close from any remote transmitter. However, you can close the door with the Door Control, the Outside Keylock, or Keyless Entry if you activate them until down travel is complete. If you release them too soon, the door will reverse.
The Opener Lights will turn on under the following conditions: When the opener is initially plugged in; when the power is interrupted; when the opener is activated. It will turn off automatically after
Lights will also turn on when someone walks through the open garage door. With a
To reengage the trolley: Pull the manual release handle toward the opener at a 45° degree angle so that the trolley release arm is horizontal. The trolley will reconnect on the next UP or DOWN operation, either manually or by pressing the Door Control push bar.
Trolley
Trolley
Release Arm
Manual |
| |
Release | NOTICE | |
Handle | ||
|
(Pull at 45° angle)
To reconnect
Operation of the
(See additional programming features, next page.)
LOCK | LIGHT |
|
Lighted Push Bar: Press to open or close the door. Press again to reverse the door during the closing cycle or to stop the door while it's opening. Light Feature: Press the Light button. If the opener lights are off, they will
Lock Feature: Designed to prevent operation of the door from portable remote controls. However, the door will open and close from the Door Control push bar and from the Outside Keylock and the Keyless Entry Accessories.
To activate: Press and hold the Lock button for
2 seconds. The push bar indicator light will flash as long
Lighted Push Bar
turn on.
If the opener lights are on, (even in the
But if you use the Light button to turn the lights on and then activate the opener, the lights will turn off after
The Light feature will not control the opener lights when the door is in motion.
as the Lock is on.
To turn off: Press and hold the Lock button again for
2 seconds. The push bar indicator light will stop flashing. Normal operation will resume. The Lock feature will also turn off whenever the “Smart” button on the opener end panel is activated.
32