NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: The Passport transmitter works with all Chamberlain 315 MHz Security✚® rolling code garage door openers and accessories.
NOTE: When using the Passport transmitter with an access system or gated entry, contact property manager for instructions on use.
NOTE: If programming a HomeLink® transmitter for an access system is required, contact property manager.
MODEL CPTX & CPTKX
REMOTE CONTROL
OWNER’S MANUAL
WARNING
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
•ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters.
•Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.
•ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.
| PROGRAMMING |
USING THE “LEARN” BUTTON | USING THE |
1
2
LOCK
LIGHT
KG
1.Press and release the “learn” button on the motor unit. The learn indicator light will glow steadily for 30 seconds.
2.Within 30 seconds, press and hold the button on the
3.Release the button when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks will be heard.
1 | 2 | 3 |
| KG | KG |
ster
1. | Press and hold the button on the |
| |
| your garage door. |
2. | While holding the remote button, press and |
| hold the LIGHT button on the |
| |
3. | Continue holding both buttons while you |
| press the push bar on the |
| Door Control (all three buttons are held). |
LiftMaster
LOCK
LIGHT
LOCK
LIGHT
WARNING
To prevent possible SERIOUS INJURY or DEATH:
•NEVER allow small children near batteries.
•If battery is swallowed, immediately notify doctor.
The lithium batteries should produce power for up to 5 years. To replace, pry open case with visor clip or screwdriver, as shown below. Insert batteries positive side up (+).
Dispose of old batteries properly.
CPT13 One | CPT23 Two | CPT33 Three |
Button Remote | Button Remote | Button Remote |
Control | Control | Control |
4. Release buttons when the motor unit lights |
blink. It has learned the code. If light bulbs |
are not installed, two clicks will be heard. |
To deactivate any unwanted remote, first erase all codes:
Press and hold the “learn” button on motor | 1 | 2 | 3 | |
unit until the learn indicator light goes out | ||||
|
|
| ||
(approximately 6 seconds). All previous codes |
|
|
| |
are now erased. Reprogram each remote or |
|
|
| |
keyless entry you wish to use. |
| KG | KG |
NOTE: Any button can be used with a garage door opener and/or access control system. However, the property manager may have restrictions on which buttons can be used when operating the gate entrance or access system.
Button Remote
Control
Remote Control
| ©2006, The Chamberlain Group, Inc. |
114A3162B | All Rights Reserved |