C O N T R O L C O N N E C T I O N D I A G R A M S
GL BOARD
J1 TERMINAL BLOCK
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 11 12 13 14 15 16 |
|
|
|
|
|
|
|
|
|
|
24 Vac ACCESSORY POWER MAY BE FOUND ON
THESE TERMINALS
R1 R2 R3 R4
24 Vac
NOTE: See wiring diagrams shipped with kit for additional information. See owner’s manual for wiring distances and wire gauge information.
WARNING: All controls that are to be used to operate the gate system, MUST be installed where the user cannot come into contact with the gate while operating the controls. Also, always install the controls where the user has full view of gate operation.
*All inputs are normally open and momentary, except the stop (N.C.). The following instructions are based upon UL325, and include recommendations for significant increase in safety.
*We strongly recommend that you follow the UL guidelines presented throughout the manual. Installation device instructions – always follow the instructions provided by the manufacturer when installing and adjusting any control device. If these instructions are contrary to the advice given here, call for assistance.
HARD CLOSE CONTROL
INPUT (N.O.)
OPEN
CLO | SE |
|
STOP
STOP/RESET
CONTROL INPUT (N.C.)
OPEN
CLOSE
STOP
SHADOW LOOP
INPUT (N.O.)
FR | EQ |
|
RESIDENTIAL RADIO
(SINGLE BUTTON) INPUT (N.O.)
SOFT OPEN
INPUT (N.O.)
1 | 2 | 3 |
| 5 | 6 |
7 | 8 | 9 |
| ||
| 0 | # |
HARD OPEN
CONTROL INPUT (N.O.)
OPEN
CLO | SE |
STOP
INTERRUPT (SAFETY) LOOP
INPUT (N.O.)
FR | EQ |
|
OBSTRUCTION OPEN
EDGE/PHOTO EYE INPUT (N.O.)
OBSTRUCTION CLOSE
EDGE/PHOTO EYE INPUT (N.O.)
34