INSTALLATION STEP 12
Connect Door Arm to Trolley
Follow instructions which apply to your door type as illustrated below and on the following page.
SECTIONAL DOORS ONLY
•Make sure garage door is fully closed. Pull the emergency release handle to disconnect the outer trolley from the inner trolley. Slide the outer trolley back (away from the pulley) about 8" (20 cm) as shown in Figures 1, 2 and 3.
•Figure 1:
–Fasten straight door arm section to outer trolley with the 5/16"x1" clevis pin. Secure the connection with a ring fastener.
–Fasten curved section to the door bracket in the same way, using the
IMPORTANT: The groove on the straight door arm MUST face away from the curved door arm (Figure 4).
• | Figure 2: |
| – Bring arm sections together. Find two pairs of holes |
| that line up and join sections. Select holes as far |
| apart as possible to increase door arm rigidity. |
• | Figure 3, Hole alignment alternative: |
| – If holes in curved arm are above holes in straight |
| arm, disconnect straight arm. Cut about 6" (15 cm) |
| from the solid end. Reconnect to trolley with cut end |
| down as shown. |
| – Bring arm sections together. |
| – Find two pairs of holes that line up and join with |
| bolts, lock washers and nuts. |
• | Pull the emergency release handle toward the opener |
| at a 45° angle so that the trolley release arm is |
| horizontal. Proceed to Adjustment Step 1, page 27. |
Figure 1
Pulley |
|
| |
8" (20 cm) min. |
| ||
Trolley | Inner | Outer | |
Stop Bolt | |||
Trolley | |||
Trolley | |||
| |||
Ring |
| ||
| Clevis Pin | ||
Fastener | 5/16"x1" | ||
|
| Emergency | |
|
| Release | |
Door |
| Handle | |
Bracket |
| Straight | |
|
| ||
|
| Door Arm | |
| Curved Door Arm | ||
Clevis Pin |
| ||
Figure 2 |
|
| |
Pulley |
|
| |
8" (20 cm) min. |
|
Trolley
Stop Bolt
Lock Washers 5/16"
Nuts
Bolts
Door Bracket
Figure 3
Pulley
8" (20 cm) min.
Trolley will |
operated. |
HARDWARE SHOWN ACTUAL SIZE
Nut
|
|
|
|
|
|
|
|
|
|
|
|
|
| Clevis Pin |
| Hex Bolt | |||
Clevis Pin |
|
|
| ||||||
|
Trolley
Stop Bolt
Nuts
Figure 4
Lock Washers 5/16"
Bolts
Cut this end
5/16"x1" (Trolley) |
CORRECTINCORRECT
Straight | Straight | |
Door Arm | ||
Door Arm | ||
| ||
Curved | Curved | |
Door Arm | Door | |
(Groove | Arm | |
| ||
facing out) |
|
25