Cisco Systems 1010 Series, 8500 Series manual

Corporate Headquarters:
Copyright © 2003 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Regulatory Compliance and Safety Information
for the Catalyst 8500 and LightStream 1010 Series
Read this document before installing or servicing the following Catalyst 8500 and LightStream 1010
series switches:
•Catalyst 8540 MSR
•Catalyst 8510 MSR
•Catalyst 8540 CSR
•Catalyst 8510 CSR
•LightStream 1010 ATM switch
Note Only trained and qualifiedservice personnel (as defined in IEC 60950 and AS/NZS 3260) should install,
replace, or service the equipment. Install the system in accordance with the U.S. National Electric Code
if you are in the United States.
Warning This warning symbol means danger.You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents.
Note The following guidelines are applicable for products intended for use in Australia:
• Only trained and qualified service personnel should install, replace, or service the equipment, as
defined by AS/NZS 3260.
• Incorrect connection of this or connected equipment to a general purpose outlet could result in a
hazardous situation.
This document includes the following sections:
•Site Preparation, page 2
•Regulatory Standards Compliance, page 9
•Translated Safety Warnings, page16