Setting up the Fiery from a Windows Computer
—Specify the IP address or server name that communicates the appropriate mail server and contact information to the Fiery.
NOTE: You must define both an Incoming and Outgoing mail server. If an Outgoing mail server is not defined, the E-mail Service assumes that the incoming and outgoing server names are the same.
—Specify the maximum amount of time that will elapse as the Fiery attempts to connect to the mail server.
—Specify how often the Fiery checks the mail server for relevant e-mail.
—Enter the mailbox name specified on the mail server. This name tells the Fiery client mail service which account contains e-mail messages for the Fiery.
NOTE: The account name entered in this field must first be specified on the mail server by the administrator.
—Enter the name of the e-mail account. For example, pat@test.com. —Enter a password for accessing the mailbox account on the mail server.
55-28
Outgoing Mail Server.
Timeout (seconds).
Polling Interval.
Mailbox Account Name.
Fiery E-mail Address.
Password.
Verify Password (remote Setup only). —Reenter your password.
Administrator E-mail Address. —Enter the address specified in Fiery setup.
The administrator authorizes a unique e-mail address to remotely administer e-mail services. If an error occurs while you are sending a job via e-mail, E-mail Service sends an error message to the Administrator E-mail Address specified. The administrator can authorize additional administrator e-mail addresses from this e-mail address.
